UL 61058-1-2
Switches for Appliances - Part 1-2: Requirements for Electronic Switches

DETAILS
Edition Number:1SCC Approved:--
Edition Date:2017-11-03DOD Approved: --
Price Code:EANSI Approved: 2017-11-03
Type:ulcsaiec

  • SCOPE

    1 Scope

    This clause of part 1 is applicable.

    Add the following at the end of Clause 1.

    This part of IEC 61058 applies to electronic switching devices and shall be used in conjunction with the general requirements of IEC 61058-1.

    NOTE Additional requirements for particular switches may be found in the relevant part 2 of IEC 61058.

  • TABLE OF CONTENTS
    Expand All

    • Cover
    • Transmittal
    • UL Harmonized Standard Title Page
    • Table of Contents
    • Deviations
    • IEC Foreword
      • SWITCHES FOR APPLIANCES – PART 1-2: REQUIREMENTS FOR ELECTRONIC SWITCHES
        • 1 Scope
        • 2 Normative References
        • 3 Terms and Definitions
        • 4 General Requirements
        • 5 General Information on Tests
        • 6 Rating
        • 7 Classification
          • 7.24 Operating cycles with mechanical switching device only (TC7)
          • 7.25 Endurance method
          • 7.26 Minimum load for electronic switches
          • 7.27 According to test conditions for electronic switches:
        • 8 Marking and Documentation
        • 9 Protection Against Electric Shock
        • 10 Provision for Earthing
        • 11 Terminals and Terminations
        • 12 Construction
        • 13 Mechanism
        • 14 Protection Against Ingress of Solid Foreign Objects, Ingress of Water and Humid Conditions
        • 15 Insulation Resistance and Dielectric Strength
        • 16 Heating
        • 17 Endurance
          • 17.1 General requirements
          • 17.2 Electrical conditions
          • 17.3 Thermal conditions
          • 17.4 Actuating conditions
          • 17.5 Type of test condition (TC)
          • 17.6 Evaluation of compliance
        • 18 Mechanical Strength
        • 19 Screws, Current-Carrying Parts and Connections
        • 20 Clearances, Creepage Distances, Solid Insulation and Coatings of Rigid Printed Board Assemblies
        • 21 Fire Hazard
        • 22 Resistance to Rusting
        • 23 Abnormal Operation and Fault Conditions for Switches
          • 23.1 Switch construction
          • 23.2 Test set-up
          • 23.3 Abnormal testing
          • 23.4 Compliance
          • 23.5 Protection in case of failure of forced cooling
        • 24 Components for Switches
        • 25 EMC Requirements