UL 60745-2-5
Hand-Held Motor-Operated Electric Tools - Safety - Part 2-5: Particular Requirements for Circular Saws

DETAILS
Edition Number:5SCC Approved:--
Edition Date:2012-03-20DOD Approved: --
Price Code:FANSI Approved: 2017-05-24
Type:ulcsaiec

  • SCOPE

    1 Scope

    This clause of part 1 is applicable, except as follows:

    Addition:

    This standard applies to circular saws, which hereinafter will be referred to as saws.

    This standard does not apply to saws designed for use with abrasive wheels.

    NOTE Saws designed for use with abrasive wheels as cut-off machines are covered by IEC 60745-2-22.

  • TABLE OF CONTENTS
    Expand All

    • Cover
    • Transmittal
    • UL Harmonized Standard Title Page
    • Table of Contents
    • Deviations
    • IEC Foreword
      • HAND-HELD MOTOR-OPERATED ELECTRIC TOOLS – SAFETY – Part 2-5: particular requirements for circular saws
        • Section
          • 1 Scope
          • 2 Normative references
          • 3 Terms and definitions
          • 4 General requirements
          • 5 General conditions for the tests
          • 6 Void
          • 7 Classification
          • 8 Marking and instructions
            • 8.12.1.101.1 Safety instructions for all saws
            • 8.12.1.101.2 Further safety instructions for all saws
            • 8.12.1.101.3 Safety instructions for saws shown in Figures , , and
            • 8.12.1.101.4 Safety instructions for saws shown in Figure
            • 8.12.1.101.5 Additional safety instructions for all saws with riving knife
          • 9 Protection against access to live parts
          • 10 Starting
          • 11 Input and current
          • 12 Heating
          • 13 Leakage current
          • 14 Moisture resistance
          • 15 Electric strength
          • 16 Overload protection of transformers and associated circuits
          • 17 Endurance
          • 18 Abnormal operation
          • 19 Mechanical hazards
            • 19.101 Guarding above the base plate
            • 19.102 Guarding below the base plate
            • 19.103 Base plate
            • 19.104 Flanges
            • 19.105 Handles
            • 19.106 Blade changing
          • 20 Mechanical strength
          • 21 Construction
          • 22 Internal wiring
          • 23 Components
          • 24 Supply connection and external flexible cords
          • 25 Terminals for external conductors
          • 26 Provision for earthing
          • 27 Screws and connections
          • 28 Creepage distances, clearances and distances through insulation
          • 29 Resistance to heat, fire and tracking
          • 30 Resistance to rusting
          • 31 Radiation, toxicity and similar hazards
        • Section
    • Annexes
    • Annex K (normative) Battery tools and battery packs
    • Annex L(normative)Battery tools and battery packs provided with mains connection or non-isolated sources
    • Annex M(normative)Safety of working stands for operation with hand-held motor-operated electric tools
    • Annex AA (normative)Additional requirements for saws with a riving knife
    • Annex BB(normative)Additional requirements for lower guards for saws without a riving knife
    • Bibliography