UL 60335-2-34
Safety of Household and Similar Electrical Appliances, Part 2-34: Particular Requirements for Motor-Compressors

DETAILS
Edition Number:5SCC Approved:--
Edition Date:2013-03-22DOD Approved: --
Price Code:HANSI Approved: 2013-03-22
Type:ulcsaiecisa

  • SCOPE

    1 Scope

    This clause of Part 1 is replaced by the following.

    This International Standard deals with the safety of sealed (hermetic and semi-hermetic type) motor-compressors, their protection and control systems, if any, which are intended for use in equipment for household and similar purposes and which conform with the standards applicable to such equipment. It applies to motor-compressors tested separately, under the most severe conditions that may be expected to occur in normal use, their rated voltage being not more than 250 V for single-phase motor-compressors and 480 V for other motor-compressors.

    1DV.1 Modification to replace the second sentence of the second paragraph in Clause 1 with the following:

    It applies to motor-compressors tested separately, under the most severe conditions that may be expected to occur in normal use, their rated voltage being not more than 300V for single-phase motor-compressors and 600 V for other motor-compressors intended for use in accordance with:

    –  CSA C22.1,  Canadian Electrical Code (CEC) Part I, and CAN/CSA-C22.2 No. 0,  General requirements – Canadian Electrical Code, Part II, in Canada;

    –  NOM-001-SEDE, La Norma de Instalaciones Electricas (Mexican Electrical Code [MEC]), in Mexico;

    –  NFPA 70,  National Electrical Code (NEC), in the United States.

    NOTE 101 Examples of equipment which contain motor-compressors are

    – refrigerators, food freezers and ice makers ( IEC 60335-2-24);

    – air-conditioners, electric heat pumps and dehumidifiers ( IEC 60335-2-40);

    – commercial dispensing appliances and vending machines ( IEC 60335-2-75);

    – factory-built assemblies for transferring heat in applications for refrigerating, air-conditioning or heating purposes or a combination of such purposes.

    NOTE 102 This standard does not supersede the requirements of standards relevant to the particular appliance in which the motor-compressor is used. However, if the motor-compressor type used complies with this standard, the tests for the motor-compressor specified in the particular appliance standard may not need to be made in the particular appliance or assembly. If the motor-compressor control system is associated with the particular appliance control system, additional tests may be necessary on the final appliance.

    So far as is practical, this standard deals with the common hazards presented by motor-compressors used in appliances which are encountered by all persons in and around the home. However, it does not in general take into account

    – the use of appliances by young children or infirm persons without supervision;

    – playing with the appliances by young children.

    NOTE 103 Attention is drawn to the fact that

    – for motor-compressors intended to be used in appliances in vehicles or on board ships, additional requirements may be necessary;

    – in many countries, additional requirements are specified by the national health authorities, the national authorities responsible for the protection of labour and similar authorities.

    NOTE 104 This standard does not apply to

    motor-compressors designed exclusively for industrial purposes;

    – motor-compressors used in appliances intended to be used in locations where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapour or gas).

    NOTE 105 If motor-compressors for refrigerant R744 used in appliances with a transcritical refrigeration system are equipped with pressure relief devices, compliance with the requirements for these devices is checked during the tests on the final appliance.

  • TABLE OF CONTENTS
    Expand All

    • Cover
    • Transmittal
    • UL Harmonized Standard Title Page
    • Table of Contents
    • Deviations
    • IEC Foreword
    • Introduction
      • HOUSEHOLD AND SIMILAR ELECTRICAL APPLIANCES – SAFETY – Part 2-34: Particular requirements for motor-compressors
        • 1 Scope
        • 2 Normative references
        • 3 Definitions
        • 4 General requirement
        • 5 General conditions for the tests
        • 6 Classification
        • 7 Marking and instructions
        • 8 Protection against access to live parts
        • 9 Starting of motor-operated appliances
        • 10 Power input and current
        • 11 Heating
        • 12 Void
        • 13 Leakage current and electric strength at operating temperature
        • 14 Transient overvoltages
        • 15 Moisture resistance
        • 16 Leakage current and electric strength
        • 17 Overload protection of transformers and associated circuits
        • 18 Endurance
        • 19 Abnormal operation
        • 20 Stability and mechanical hazards
        • 21 Mechanical strength
        • 22 Construction
        • 23 Internal wiring
        • 24 Components
        • 25 Supply connection and external flexible cords
        • 26 Terminals for external conductors
        • 27 Provision for earthing
        • 28 Screws and connections
        • 29 Clearances, creepage distances and solid insulation
        • 30 Resistance to heat and fire
        • 31 Resistance to rusting
        • 32 Radiation, toxicity and similar hazards
    • Annexes
    • Annex C(normative)Aging test on motors
    • Annex D(normative)Alternative requirements for protected motor units
    • Annex AA(normative)Running overload tests for motor-compressors classified as tested with Annex AA
    • Annex DVA(informative)Component Standards Cross Reference
    • Annex 101.DVBB(normative)Accelerated Aging Tests – Gaskets
    • Annex 101.DVCCRefrigeration Code(informative)
    • Annex 101.DVDD(normative)Nonmetallic Materials
    • Annex 101.DVEE(normative)Bypass valve testing
    • Annex 101.DVFF(informative)Supplemental requirements
    • Annex 101.DVGG(informative)Optional Fatigue Test
    • Annex 101.DVHH(informative)Maximum Continuous Current Test
    • Bibliography