UL 1477
Outline of Investigation for Compressed Gas Shutoff Valves

Edition Number:4SCC Approved:--
Edition Date:2014-07-25DOD Approved: --
Price Code:AANSI Approved: --


    1 Scope

    1.1 These requirements cover manually operated shutoff and metering valves used in compressed and fuel gas piping systems, including manifolds, and with equipment and appliances as defined herein, other than those for anhydrous ammonia and are usually designated as gas-line service valves.

    1.2 Shutoff valves covered by these requirements are for use in systems and facilities where complete shutoff is required. Metering type valves are used in piping and equipment systems where complete shutoff is not required.

    1.3 Shut-off valves of the type commonly referred to as "cylinder valves" used on containers constructed under Department of Transportation (DOT) or Transport Canada (TC) Specifications are covered by the requirements in the Standard for Cylinder Valves, UL 1769.

    1.4 Gas-line shut-off valves for use with liquefied petroleum gases, within the scope of NFPA 58,  LP-Gas Code, or anhydrous ammonia within the scope of Safety Requirements for the Storage and Handling of Anhydrous Ammonia, ANSI/CGA G-2.1 (ANSI 61.1K) are covered by the requirements in the Standard for Flow Control Valves for Anhydrous Ammonia and LP-Gas, UL 125.

    1.5 Automatic shutoff valves that would use pressure, temperature (heat) or electricity or combination of such for operation and self-closing types are covered by the requirements in the Standard for Valves for Flammable Fluids, UL 842 or the Standard for Electrically Operated Valves, UL 429.

    1.6 These requirements do not apply to valves for compressed gases for use in refrigerated storage systems.

    1.7 Except for such observations as are required to ascertain performance characteristics, the assigning of flow capacity ratings are not within the scope of these requirements.

    Expand All

    • Outline Title Page
    • Table of Contents
      • Body
          • 1 Scope
          • 2 General
            • 2.1 Components
            • 2.2 Units of measurement
          • 3 Glossary
          • 4 Pressure and Temperature Rating
          • 5 General
          • 6 Bodies
          • 7 Materials
          • 8 Seals and Stuffing Boxes
          • 9 Springs
          • 10 Operating Mechanisms
          • 11 General
          • 12 Deformation Test
          • 13 External Leakage Test
          • 14 Seat Leakage Test
          • 15 Endurance Test
          • 16 Hydrostatic Pressure
          • 17 Accelerated Aging Test
          • 18 Fluid Compatibility Test
          • 19 Low Temperature Test
          • 20 Moist Ammonia Air Stress Cracking Test
          • 21 Impact Test
          • 22 Accelerated Hydrogen-Pressure Aging Test
          • 23 Handwheel-Stem Torque Test
          • 24 General
        • MARKING
          • 25 General